Flats with optolong l-enhance

Questions and answers about processing in StarTools and how to accomplish certain tasks.
Post Reply
mgutierrez
Posts: 59
Joined: Sat Oct 24, 2020 11:07 pm

Flats with optolong l-enhance

Post by mgutierrez »

Hi all,

Since I see there are some users using this filter, I have the following question.
I'm trying to get flat frames with an Optolong L-Enhance filter. Without the filter I get good quality flats, but with the filter the histogram shows the three color channels quite separated. I guess is normal in such filters, but the case is that I don't notice any difference between applying these flats and without them. So my guess is I'm doing something wrong.
Sample:
Selection_057.jpg
Selection_057.jpg (88.34 KiB) Viewed 2421 times
Thanks!
fmeireso
Posts: 384
Joined: Mon Sep 28, 2020 8:46 pm
Location: Belgium

Re: Flats with optolong l-enhance

Post by fmeireso »

Got the blueish flats too....

Guess still they worked ok...could not see dust spots ,i am sure i have plenty on my sensor...
User avatar
admin
Site Admin
Posts: 3381
Joined: Thu Dec 02, 2010 10:51 pm
Location: Melbourne
Contact:

Re: Flats with optolong l-enhance

Post by admin »

The color of your flats should have no bearing on how well they work. In fact, meddling with their coloring can artificially increase noise in your flats (which then get imprinted on your calibrated lights!).
Ivo Jager
StarTools creator and astronomy enthusiast
Post Reply