Mike in Rancho wrote: ↑Sat Aug 13, 2022 1:53 am
Dietmar, that does not look like one of the bicolor compositing options.
Oops, you’re right, Mike! Thank you for paying attention.
Steve, Freddy, I’m sorry . I copied the wrong parameter value. It should indeed be [L + Synthetic L From R(2xG)B, R(GB)(GB) (Bi-Color from OSC/DSLR)] as written in Ivo’s post.
So, like this
2022-08-13 10_41_46-Window.jpg (25.71 KiB) Viewed 2262 times
This leads in the end more or less automatically to something like this
2022-08-13 11_35_41-Window.jpg (78.89 KiB) Viewed 2262 times
Best regards, Dietmar.
P.S.: As for your NB/RGB combination, Freddy, I think it's better if Mike answers.
Hmm, meanwhile i still going to try it. The red in the picture looks better, and the cyan can be adjusted afterwards in GIMP.
I don't like the magenta in my pictures but that is difficult to alter for some reason afterwards.
Freddy, yes, my hint was more for the HOO / bicolour processing Steve did in his case.
fmeireso wrote: ↑Sat Aug 13, 2022 10:57 am
The red in the picture looks better, and the cyan can be adjusted afterwards in GIMP.
I admit, I sometimes do a little postprecessing with darktabe or GIMP, but most times only for brightness / gamma corrections. For colour processing, I think it should be possible to use just the Compose / Color module
As Mike wrote, you maybe should consider to link your stacks. People here are very contructive and could give great help.
[L + Synthetic L From R(2xG)B, R(GB)(GB) (Bi-Color from OSC/DSLR)
Hi
With an 600d, by far the noisiest channel is the B. The main advantage of splitting the channels is that you don't have to use B at all. G carries the same colour data as the B, but is much cleaner. That's with our UHC filter. I believe the l-eNhance is similar.
Cheers
alacant wrote: ↑Sun Aug 14, 2022 7:45 am
With an 600d, by far the noisiest channel is the B.
I understand, that's interesting. I will have to check my data sets for that. That must be a lot of noise, that it is better to to omit B and to loose a lot of signal / integration time, noisy or not.
Do you think, this noise in B is from your camera? Or due to light pollution?
Best regards, Dietmar.
Edit: I think, the G channel has usually better SNR with DSLR because there are twice as much pixels?! Just a thought ...
. I copied the wrong parameter value. It should indeed be [L + Synthetic L From R(2xG)B, R(GB)(GB) (Bi-Color from OSC/DSLR)] as written in Ivo’s post.