Page 1 of 1
Decon: allow user to set values
Posted: Tue Jul 07, 2020 2:50 pm
by alacant
1.6.396rc
Hi Ivo, everyone
Decon: Rather than beginning the Default deconvolution, allow the user to set the parameters first?
Cheers,
Steve
Re: Decon: allow user to set values
Posted: Fri Jul 10, 2020 5:25 am
by admin
Hi Stebve,
Apologies for the slight delay (released 1.6, 1.7 alpha, today).
All modules will process as much stuff in the background as possible. Whenever you change a parameter, any processing is aborted and processing immediately restarted. So, really, you can start changing parameters straight away without delay or consequences.
Does that help?
Re: Decon: allow user to set values
Posted: Sat Jul 11, 2020 6:46 am
by alacant
Hi Ivo
Yes, that's fine. The point being that whilst it's processing the default, you can't change anything. You have to wait until it finished the gaussian before you can do anything. But not a problem. Just an idea.
Cheers
**EDIT: Just seen 1.7. Much better:)