Page 1 of 1
STv1.4 Speckling With Decon
Posted: Sat Dec 05, 2015 1:30 pm
by KD0NPT-Astro
Tried using the Decon module in version 1.4 but image gets splattered with fine white speckling in random areas.
Went back to version 1.3 and it is fine.
Re: STv1.4 Speckling With Decon
Posted: Sun Dec 06, 2015 12:44 pm
by KD0NPT-Astro
KD0NPT-Astro wrote:Tried using the Decon module in version 1.4 but image gets splattered with fine white speckling in random areas.
Went back to version 1.3 and it is fine.
Used version 1.3 several times yesterday and it also did a random speckling over the image in Decon.
Using Windows7-64 with 16G memory. Nvidia graphic chipset.
Re: STv1.4 Speckling With Decon
Posted: Sun Dec 06, 2015 1:14 pm
by smokey688i
I've had issues with this same thing, although I usually don't have an issue in 1.4. Best route for success that I've found is decon first thing after the bin, crop, wipe, develop steps - when I do anything else first is when I start to get random white pixels pop up in decon.
Re: STv1.4 Speckling With Decon
Posted: Sun Dec 06, 2015 1:39 pm
by KD0NPT-Astro
Went ahead and used V1.4 again this morning and did a new reprocessing of the same image. Entered DECON and it prompted to generate an automatic mask. The mask it generated was just a bunch of random groups of non-stars across the image. Clicked on Mask and entered that menu, chose Auto again, then Stars, it then made a mask with all the stars in "green", I also did one shrink and then chose Keep. After it left the mask area a message pops up and says not enough pixels have been selected. Tried the Invert function, background turns green, Stars are white. No change in image after processing.
How can that be? The Before and After shows no change.
No speckling occurred for this session.
Re: STv1.4 Speckling With Decon
Posted: Sun Dec 06, 2015 5:40 pm
by smokey688i
It might still be working...I honestly can't tell the difference unless I zoom in and click back and forth several times. The difference is very subtle but the best way to describe it is a slight sharpening and decrease in fuzziness in my experience. I usually go with the default settings with my data, otherwise the image graininess starts to increase too much for my liking...your mileage may vary.
Chris
Re: STv1.4 Speckling With Decon
Posted: Sun Dec 06, 2015 7:16 pm
by Cheman
If you dont see any/much difference in decon, try increasing the radius size. Sometimes I have to do that, and keep doing it until I either see an improvement, or determine that it is not helping
Che
Re: STv1.4 Speckling With Decon
Posted: Mon Dec 07, 2015 12:01 am
by KD0NPT-Astro
Cheman wrote:If you dont see any/much difference in decon, try increasing the radius size. Sometimes I have to do that, and keep doing it until I either see an improvement, or determine that it is not helping
Che
When it happens they speckles are prett bright. I ran it all day today with the default and did not happen again.