StarTools

I have noticed during the 'wipe' process that I seem to be unable to cancel an option. Suppose I click 'vignetting', see the result and then wish to 'cancel' that option and try other options. I am not certain how to proceed apart from cancelling the whole process and restarting wipe. Sometimes during parameter changes in 'wipe' something is good and I then wish to further modify the result with another parameter change (such as using the icons at the top left). If I wish to 'back out' of one option I cannot apparently do so. If this makes sense, can anyone advise? If it doesn't make sense, please say so

FWIW I am very pleased with my learning curve with ST but need much more practise.

regards

Lawrence Harris

Hi Lawrence.

You should be able to select any option, Gradient Vignetting etc., and see changes in the sliders below. Of course, nothing happens unless 'Do' is selected, to render a new preview.

If 'nothing' changes when you select options from the top row then it is perhaps a bug. No doubt you have had a look at the User Notes section.